Home › Vehicle Interior › LIGHTING (INT) › RELAY
RM30B0U _58 Vehicle Interior _010070 LIGHTING (INT) _0057957 RELAY G

LIGHTING (INT)  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT LIGHT CUT RELAY

a.

Remove the fuse box opening cover.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>REMOVAL


b.
E270409

Detach the clamp.


c.
E270410

Remove the light cut relay.


d.
E256070
2.281,1.417 2.583,1.323 false 2.813,1.479 3.01,1.438 false 2.792,1.125 2.667,1 false 2.906,0.792 2.667,0.656 false 0.271,1.375 0.427,1.573 0.156,0.198 10 1 1.573,1.375 1.729,1.573 0.156,0.198 10 2 0.271,0.656 0.427,0.854 0.156,0.198 10 3 1.573,0.875 1.729,1.073 0.156,0.198 10 5 2.927,0.719 3.083,0.917 0.156,0.198 10 3 2.823,1.063 2.979,1.26 0.156,0.198 10 5 2.729,1.406 2.885,1.604 0.156,0.198 10 1 2.615,1.229 2.771,1.427 0.156,0.198 10 2

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the light cut relay.



e.

Install the light cut relay.


f.