When the ignition switch is turned to ON, the occupant detection ECU sends a signal to the airbag sensor assembly to indicate the state of the front seat inner belt assembly RH and also whether the front passenger seat is occupied. The airbag sensor assembly sends those signals to the combination meter assembly via CAN communication. The combination meter assembly illuminates, blinks or turns off the front seat belt warning light on the combination meter assembly in accordance with these signals.
The front seat belt warning light on the combination meter assembly is used for both the driver side seat and front passenger side seat.
The seat belt warning system uses the CAN communication system. First, confirm that there is no malfunction in the CAN communication system. Refer to the How to Proceed with Troubleshooting procedure.
Click hereVehicle Interior>SEAT BELT>SEAT BELT WARNING SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Clear the DTCs.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>OCCUPANT CLASSIFICATION SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>OCCUPANT CLASSIFICATION SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTCs are not output |
| DTCs are output |
DTCs are not output
DTCs are output
Clear the DTCs.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTCs are not output |
| DTCs are output |
DTCs are not output
DTCs are output
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Occupant Detection / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Passenger Buckle SW | Front passenger side buckle switch | Set, Unset or NG | Set: Front seat belt RH fastened
Unset: Front seat belt RH not fastened NG: Data is not determined |
- |
| Tester Display |
|---|
| Passenger Buckle SW |
| Result | Proceed to |
|---|---|
| Unset or Set is displayed on the Techstream screen according to the front passenger side seat belt condition | A |
| Unset or Set is not displayed normally on the Techstream screen according to the front passenger side seat belt condition | B |
| NG is displayed on the Techstream screen | C |
A
B
C
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / SRS Airbag / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Right side Buckle SW | Front passenger side buckle switch | Unset, Set or NG | Unset: Front seat belt RH is not fastened
Set: Front seat belt RH is fastened NG: Data is not determined |
- |
| Tester Display |
|---|
| Right side Buckle SW |
| Result | Proceed to |
|---|---|
| Unset or Set is displayed on the Techstream screen according to the front passenger side seat belt condition | A |
·
Unset or Set is not displayed normally on the Techstream screen according to the front passenger side seat belt condition ·
NG is displayed on the Techstream screen |
B |
A
B