The master cylinder pressure sensor is connected to the skid control ECU (brake actuator assembly).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1281 | Master Cylinder Pressure Sensor Output Malfunction (Test Mode DTC) | Detected only during Test Mode. | Brake actuator assembly (Master cylinder pressure sensor) |
| C1421 | Open or Short in Master Cylinder Pressure Sensor | Either of the following is detected:
1.
With the IG1 terminal voltage between 9.5 and 17.4 V, the VCM terminal voltage is not between 4.4 and 5.6 V for 1.2 seconds or more. 2.
When the VCM terminal voltage is between 4.8 and 5.2 V, the PMC terminal voltage is not between 0.19 and 4.57 V for 1.2 seconds or more. |
Brake actuator assembly (Master cylinder pressure sensor) |
| C1423 | Master Cylinder Pressure Sensor Zero Point Low Malfunction | The PMC terminal voltage is less than 0.27 V for 5 seconds or more. | Brake actuator assembly (Master cylinder pressure sensor) |
| C1424 | Master Cylinder Pressure Sensor Output Malfunction | Any of the following is detected:
1.
Noise occurs in the PMC terminal 7 times or more within 5 seconds. 2.
When the vehicle speed drops from 40 km/h (25 mph) to 10 km/h (6 mph), the master cylinder pressure does not change by at least 0.048 MPa. 3.
At a vehicle speed of 7 km/h (4.3 mph) or more, the PMC terminal voltage is between 0.86 and 1.0 V and does not change by at least 0.048 MPa for 60 seconds or more. 4.
At a vehicle speed of 7 km/h (4.3 mph) or more, the PMC terminal voltage is 1.0 V or more and does not change by at least 0.048 MPa for 30 seconds or more. 5.
At a vehicle speed of 7 km/h (4.3 mph) or more with the stop switch ON, a state in which the pressure sensor input value is sufficiently greater than the estimated master pressure continues for 1 second or more and this state occurs 5 or more times each time the ignition switch is turned to ON, and this occurs 8 or more times consecutively. |
Brake actuator assembly (Master cylinder pressure sensor) |
Refer to DTC C1425.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C1425
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION
Replace the brake actuator assembly (master cylinder pressure sensor).
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT