The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.
The combination meter assembly has a built-in buzzer.
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION
Check if CAN communication system DTCs are output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Proceed to |
|---|
| DTC is not output |
| DTC is output |
DTC is not output
DTC is output
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
According to the display on the Techstream, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Buzzer | meter buzzer | ON/OFF | Buzzer can be heard
Vehicle condition: Vehicle stopped |
When performing the Buzzer Active Test, check Buzzer in the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Buzzer | Meter buzzer | ON or OFF | OFF: Buzzer off
ON: Buzzer on |
The combination meter assembly has a built-in buzzer. |
| Active Test Display |
|---|
| Buzzer |
| Data List Display |
|---|
| Buzzer |
| Result | Proceed to |
|---|---|
| Buzzer in the Data List does not change using the Active Test | A |
| Buzzer in the Data List turns ON/OFF using the Active Test | B |
A
B
Inspect the combination meter.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>PROBLEM SYMPTOMS TABLE
| Result |
|---|
| OK |
| NG |
OK
NG