Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM30B0U _55 Steering _010850 STEERING COLUMN _0058247 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  REASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 1.INSTALL POWER STEERING MOTOR ASSEMBLY

a.

Apply grease to the spline part of the electric power steering column sub-assembly.


b.
C275628

Install the power steering motor assembly with the 2 bolts.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


c.

Place new heat resistant tape.

NOTICE:

As heat from the power steering motor assembly may generate smoke, use heat resistant tape (resistant to 100°C (212°F) or higher).



Hide 2.INSTALL POWER STEERING ECU ASSEMBLY

Hide 3.INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Smart Key System)

a.
C280248

Turn the ignition switch to ACC.


b.

Install the ignition switch lock cylinder assembly into the upper steering column bracket assembly.


c.

Make sure that the ignition switch lock cylinder assembly is securely fixed onto the ignition switch lock cylinder assembly.


Hide 4.INSTALL UNLOCK WARNING SWITCH ASSEMBLY (w/o Smart Key System)

a.
C233276

Attach the 2 claws to install the unlock warning switch assembly onto the upper steering column bracket assembly.

HINT:

Slide the unlock warning switch assembly in the direction shown by the arrow in the illustration to install it.



Hide 5.INSTALL KEY INTERLOCK SOLENOID

C280247

a.

Install the key interlock solenoid onto the upper steering column bracket assembly with the screw.


Hide 6.INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (w/o Smart Key System)

Hide 7.INSTALL TRANSPONDER KEY COIL (w/o Smart Key System)

Hide 8.INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/ Smart Key System)

HINT:

When replacing the steering lock actuator assembly, perform the key registration (Click here Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM(w/ Smart Key System)>REGISTRATION).


a.

Temporarily install the steering lock actuator assembly with a new tapered-head bolt.

NOTICE:

Be sure to use a new tapered-head bolt.



b.
C275672
0.833,1.813 1.25,1.396 true 1.854,2.656 2.073,2.01 true 0.719,1.792 0.875,1.99 0.156,0.198 10 2 1.781,2.667 1.938,2.865 0.156,0.198 10 1

Tighten the tapered-head bolts until the bolt head breaks off.

HINT:

Tighten the nuts in the order shown in the illustration.



Hide 9.INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/o Smart Key System)

HINT:

Refer to "INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)"