1.INSTALL BLIND SPOT MONITOR SENSOR LH
Avoid any impact to the blind spot monitor sensor LH.
Do not drop the blind spot monitor sensor LH. If it is dropped, replace it with a new one.
Connect the connector.
Install the blind spot monitor sensor LH with the 3 nuts.
2.INSTALL BLIND SPOT MONITOR SENSOR RH
Avoid any impact to the blind spot monitor sensor RH.
Do not drop the blind spot monitor sensor RH. If it is dropped, replace it with a new one.
Connect the connector.
Install the blind spot monitor sensor RH with the 3 nuts.
3.INSTALL REAR BUMPER COVER
4.INSTALL QUARTER PANEL MUDGUARD REAR LH (w/ Mudguard)
5.INSTALL QUARTER PANEL MUDGUARD REAR RH (w/ Mudguard)
6.PERFORM BLIND SPOT MONITOR BEAM AXIS INSPECTION
7.PERFORM DIAGNOSTIC SYSTEM CHECK