Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)
RM30B0U _59 Vehicle Exterior _010076 WINDOW / GLASS _0058468 POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function) C

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)  B2313  Glass Position Initialization Incomplete  


DESCRIPTION

The front power window regulator motor assembly LH is operated by the power window regulator master switch assembly. The front power window regulator motor assembly LH has motor and ECU functions.

When the ECU determines that the front power window regulator motor assembly LH has not been initialized, DTC B2313 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
B2313 Glass Position Initialization Incomplete Either condition is met:
·

Front power window regulator motor assembly LH not initialized

·

Front power window regulator motor assembly LH is malfunctioning

·

Battery disconnected when ignition switch is ON


·

Front power window regulator motor assembly LH not initialized

·

Front power window regulator motor assembly LH



CAUTION / NOTICE / HINT

NOTICE:
·

DTC B2313 is stored in the front power window regulator motor assembly LH.

·

If the battery is disconnected while the ignition switch is ON, DTC B2313 is stored.

·

If the front power window regulator motor assembly LH has been replaced with a new one, initialize the power window control system.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>INITIALIZATION



PROCEDURE

1.PERFORM INITIALIZATION
a.

Initialize the front power window regulator motor assembly LH.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>INITIALIZATION


Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Turn the ignition switch off.


b.

Wait for at least 10 seconds, and then turn the ignition switch to ON.


c.

Check for DTCs.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>DTC CHECK / CLEAR

Body Electrical > D-Door Motor > Trouble Codes
50001 124

Result:
Proceed to
DTC B2313 is not output
DTC B2313 is output



DTC B2313 is not output

END (PROBLEM DUE TO INITIALIZATION FAILURE)

DTC B2313 is output

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH