Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › IMMOBILISER SYSTEM(w/ Smart Key System)
RM30B0U _58 Vehicle Interior _009405 THEFT DETERRENT / KEYLESS ENTRY _0059577 IMMOBILISER SYSTEM(w/ Smart Key System) C

THEFT DETERRENT / KEYLESS ENTRY  IMMOBILISER SYSTEM(w/ Smart Key System)  B278D  Malfunction of ID-BOX Recognition  


DESCRIPTION

When the certification ECU (smart key ECU assembly) detects an input signal indicating that the vehicle is equipped with an ID code box (immobiliser code ECU) even though the ID code box (immobiliser code ECU) is not registered, the certification ECU (smart key ECU assembly) stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B278D Malfunction of ID-BOX Recognition One of the following conditions is met:
·

The certification ECU (smart key ECU assembly) recognizes that the wire harness judging whether the vehicle is equipped with an ID code box (immobiliser code ECU) or not is provided even though the ID code box (immobiliser code ECU) is not registered.

·

The certification ECU (smart key ECU assembly) receives a LIN signal from the ID code box (immobiliser code ECU) even though the ID code box (immobiliser code ECU) is not registered.

·

The certification ECU (smart key ECU assembly) receives a LIN signal from the ID code box (immobiliser code ECU) even though the wire harness judging whether the vehicle is equipped with an ID code box (immobiliser code ECU) or not is not provided.


Misconnection of the ID code box (immobiliser code ECU) DTC output confirmation operation:

Always



Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Operation when Malfunction Detected
Key registration will be prohibited -

Related Data List and Active Test
DTC No. Data List and Active Test
B278D -

CAUTION / NOTICE / HINT

NOTICE:
·

Before performing following procedure, check that the ID code box (immobiliser code ECU) is not installed on the vehicle.

·

Before replacing the certification ECU (smart key ECU assembly), refer to the registration.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM(w/ Smart Key System)>REGISTRATION

·

After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation."



PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM(w/ Smart Key System)>DTC CHECK / CLEAR

Body Electrical > Smart Key > Clear DTCs
50002 125

Result:
Proceed to
NEXT



NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT
a.

Check for DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM(w/ Smart Key System)>DTC CHECK / CLEAR

Body Electrical > Smart Key > Trouble Codes
50001 125
HINT:

Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.



Result:
Proceed to
DTC B278D is not output
DTC B278D is output



DTC B278D is not output

END

DTC B278D is output

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)