Home › Brake › PARKING BRAKE › PARKING BRAKE SYSTEM
RM30B0U _54 Brake _011370 PARKING BRAKE _0059596 PARKING BRAKE SYSTEM N

PARKING BRAKE  PARKING BRAKE SYSTEM  ADJUSTMENT  


PROCEDURE

Hide 1.CHECK PARKING BRAKE LEVER TRAVEL

a.

Pull the lever upward with a force of approximately 200 N (20 kgf, 45 lbf) and count the number of clicks.

OK:

6 to 8 clicks (without rear brake dragging)



Hide 2.REMOVE REAR WHEEL

Hide 3.REMOVE REAR CONSOLE BOX SUB-ASSEMBLY

Hide 4.ADJUST PARKING BRAKE LEVER TRAVEL

a.

Completely release the parking brake lever.


b.
C278484
1.792,0.948 1.938,0.51 1.938,0.51 2.146,0.51 false 0.677,1.167 1.552,1.167 false 2.188,0.417 2.531,0.698 0.344,0.281 10 *1 0.49,1.083 0.854,1.385 0.365,0.302 10 *2
*1 Lock Nut
*2 No. 1 Cable Adjusting Nut


Loosen the lock nut and No. 1 cable adjusting nut to completely release the parking brake cable.


c.

Temporarily install the hub nuts.


d.
C266006
1.063,0.74 1.146,0.729 false
V100135

Shoe Adjuster Contracts
V100136

Shoe Adjuster Expands


Remove the shoe adjusting hole plug, and then turn the adjuster to expand the shoe adjuster until the disc locks.


e.

Turn the shoe adjuster so that it contracts to a point where the disc can rotate smoothly.

Standard:

8 notches



f.

Check that the shoe has no brake drag.


g.

Install the shoe adjusting hole plug.


h.

Remove the hub nuts.


i.
C278484
1.792,0.948 1.938,0.51 1.938,0.51 2.146,0.51 false 0.677,1.167 1.552,1.167 false 2.188,0.417 2.531,0.698 0.344,0.281 10 *1 0.49,1.083 0.854,1.385 0.365,0.302 10 *2
*1 Lock Nut
*2 No. 1 Cable Adjusting Nut


Turn the No. 1 cable adjusting nut until the lever travel is correct.

OK:

6 to 8 clicks (without rear brake dragging)

<Lever pulling force: approximately 200 N (20 kgf, 45 lbf)>



j.

Tighten the lock nut.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


k.

Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.

OK:

6 to 8 clicks (without rear brake dragging)

<Lever pulling force: approximately 200 N (20 kgf, 45 lbf)>



l.

When operating the parking brake lever, check that the brake warning light illuminates at the first click.

OK:

The brake warning light always illuminates at the first click.



Hide 5.INSTALL REAR CONSOLE BOX SUB-ASSEMBLY

Hide 6.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)