Home › Drivetrain › GF1A TRANSFER / 4WD / AWD › 4WD CONTROL ECU
RM30B0U _52 Drivetrain _009983 GF1A TRANSFER / 4WD / AWD _0060055 4WD CONTROL ECU A

GF1A TRANSFER / 4WD / AWD  4WD CONTROL ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.REMOVE DEFROSTER NOZZLE ASSEMBLY

Hide 5.REMOVE HEATER TO REGISTER DUCT ASSEMBLY

Hide 6.REMOVE 4WD ECU ASSEMBLY

C278887

a.

Disconnect the connector.


b.

Remove the bolt and 4WD ECU assembly.