1.REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY
2.REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY
3.REMOVE REAR NO. 1 DIFFERENTIAL MOUNT CUSHION
Using SST, remove the rear No. 1 differential mount cushion.
| *1 | Rear Suspension Member Sub-assembly | - | - |
|
Front of Vehicle | - | - |
Do not bring SST into contact with the rear suspension member sub-assembly.
Before using SST, apply grease to SST bolt.
Set SST in the correct direction.
Do not tilt the bolt of SST.
Do not reuse the rear No. 1 differential mount cushion.