Home › Drivetrain › AXLE AND DIFFERENTIAL › DIFFERENTIAL MOUNT CUSHION
RM30B0U _52 Drivetrain _009469 AXLE AND DIFFERENTIAL _0051201 DIFFERENTIAL MOUNT CUSHION A

AXLE AND DIFFERENTIAL  DIFFERENTIAL MOUNT CUSHION  INSTALLATION  


PROCEDURE

Hide 1.INSTALL REAR NO. 1 DIFFERENTIAL MOUNT CUSHION

a.

Using SST, install a new rear No. 1 differential mount cushion.

SST
09316-12010  09570-24011  

C279649
5.813,0.646 5.813,0.271 5.813,0.271 6.323,0.271 false 6.156,0.521 6.146,0.271 false 1.167,1.76 0.948,1.76 0.948,1.76 0.948,1.604 false 5.99,1.427 6.583,1.427 false 6.146,2.094 6.458,2.292 0.313,0.198 10 *a 6.24,1.479 6.552,1.677 0.313,0.198 10 *b 6.375,0.208 6.833,0.406 0.458,0.198 10 SST 1.229,1.677 1.688,1.875 0.458,0.198 10 SST 6.635,1.344 6.958,1.667 0.323,0.323 10 *1
*1 Rear Suspension Member Sub-assembly - -
*a 0° +/- 3° *b 5.0 to 6.0 mm (0.197 to 0.236 in.)
V100136

Front of Vehicle - -


NOTICE:
·

Make sure that the differential mount cushion is aligned within 3° from the center.

·

Be sure to use the correct combination of SST.

·

Before using SST, apply grease to SST bolt.

·

Temporarily install the rear No. 1 differential mount cushion to the rear suspension member sub-assembly in order to prevent it from tilting, and then install SST.

·

Make sure that SST contacts the entire circumference of the rear No. 1 differential mount cushion.

·

Do not tilt the bolts of SST.




Hide 2.INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

Hide 3.INSTALL REAR DIFFERENTIAL CARRIER SUB-ASSEMBLY