1.REMOVE REAR CONSOLE BOX SUB-ASSEMBLY
2.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
3.REMOVE NO. 1 POWER OUTLET SOCKET ASSEMBLY
| *1 | Protective Tape |
Using a screwdriver, detach the claw to remove the No. 1 power outlet socket assembly.
Tape the screwdriver tip before use.
Use the same procedure to remove the other No. 1 power outlet socket assembly.
4.REMOVE NO. 1 POWER OUTLET SOCKET COVER
Detach the 2 claws and remove the No. 1 power outlet socket cover.
Use the same procedure to remove the other No. 1 power outlet socket cover.