1.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
2.REMOVE HOOD TO FRONT FENDER SEAL RH
Remove the clip.
Detach the 3 clips and remove the hood to front fender seal RH.
3.REMOVE HOOD TO FRONT FENDER SEAL LH
Use the same procedure described for the RH side.
4.REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY
5.REMOVE FRONT DOOR SCUFF PLATE LH
6.REMOVE COWL SIDE TRIM BOARD LH
7.REMOVE FUSE BOX OPENING COVER
8.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Detach the 3 claws.
Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.
9.REMOVE HOOD LOCK ASSEMBLY
Remove the 3 bolts.
Disconnect the hood lock control cable assembly and remove the hood lock assembly.
10.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY
| *1 | String |
Tie a string to the end of the hood lock control cable assembly as shown in the illustration.
Use a length of string long enough to pass through the engine compartment.
Detach each clamp, and then pull out the hood lock control cable assembly from the vehicle body.
Untie the string from the hood lock control cable assembly.
| *1 | Hood Lock Control Cable | *2 | Stopper |