When the power back door cannot be closed using the door control switch assembly, either of the following may be malfunctioning: 1) door control switch assembly circuit or 2) multiplex network door ECU.
Check the Data List to determine if the door control switch assembly functions properly.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| PBD Close SW | Door control switch assembly signal | ON or OFF | ON: Door control switch assembly pushed
OFF: Door control switch assembly not pushed |
- |
| Tester Display |
|---|
| PBD Close SW |
The door control switch assembly functions as specified in the normal condition column.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the door control switch assembly.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR CLOSER SWITCH>REMOVAL
Inspect the door control switch assembly.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR CLOSER SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the U17 door control switch assembly connector.
Disconnect the U18 multiplex network door ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| U17-1 (CLS) - U18-6 (BDDN) | Always | Below 1 Ω |
| U17-2 (E) - Body ground | Always | Below 1 Ω |
| U17-1 (CLS) or U18-6 (BDDN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG