1.REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL
2.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
3.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL
4.REMOVE UPPER INSTRUMENT CLUSTER FINISH PANEL
5.REMOVE FUSE BOX OPENING COVER
6.REMOVE NO. 2 SWITCH HOLE BASE
Detach the 3 clips and claw and remove the No. 2 switch hole base.
7.REMOVE BACK DOOR CONTROL SWITCH
Detach the 2 claws and remove the back door control switch assembly as shown in the illustration.
Disconnect the connector.