1.INSPECT TIRES
Check the tires for wear and proper inflation pressure.
| Tire Size | Front
kPa (kgf/cm2, psi) |
Rear
kPa (kgf/cm2, psi) |
|---|---|---|
| 225/65R17 102H | 230 (2.3, 33) | 230 (2.3, 33) |
| 235/55R18 100H | 220 (2.2, 32) | 220 (2.2, 32) |
| Tire Size | kPa (kgf/cm2, psi) |
|---|---|
| T165/80R17 104M | 420 (4.2, 60) |
Using a dial indicator, check the runout of the tires.
1.4 mm (0.0551 in.) or less
2. ROTATE TIRES
| *A | w/ Full Size Spare Tire |
| *B | w/o Full Size Spare Tire |
| *a | Front of the Vehicle |
Rotate the tires as shown in the illustration.
3.INSPECT WHEEL BALANCE
for Aluminum Wheel Type:
Check and adjust the off-the-car balance.
8.0 g (0.0176 lb.)
Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
Do not touch the sticking surface of the tape.
Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.
25 mm (0.984 in.)
Push the balance weight firmly to adhere it to the position.
Do not reuse the balance weight.
The inner side balance weights should be installed by clipping them to the rim.
If necessary, check and adjust the on-the-car balance.
for Steel Wheel Type:
Check and adjust the off-the-car balance.
8.0 g (0.0176 lb.)
If necessary, check and adjust the on-the-car balance.
4.INSPECT FRONT AXLE HUB BEARING LOOSENESS
5.INSPECT FRONT AXLE HUB RUNOUT
6.INSPECT REAR AXLE HUB BEARING LOOSENESS
7.INSPECT REAR AXLE HUB RUNOUT