Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER › from 2013.11
RM30B0U _56 Audio / Visual / Telematics _009009 NAVIGATION / MULTI INFO DISPLAY _0103736 NAVIGATION RECEIVER A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION RECEIVER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

Hide 4.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 5.REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 6.REMOVE TELLTALE LIGHT ASSEMBLY

Hide 7.REMOVE NAVIGATION RECEIVER ASSEMBLY

a.
E288844

Remove the 4 bolts.


b.

Detach the 4 clips and remove the navigation receiver assembly with bracket.


c.

Disconnect each connector.


Hide 9.REMOVE NO. 1 RADIO BRACKET

E288776

a.

Remove the 5 screws and No. 1 radio bracket.


Hide 10.REMOVE NO. 2 RADIO BRACKET

E288775

a.

Remove the 5 screws and No. 2 radio bracket.


Hide 11.REMOVE STEREO COMPONENT TUNER ASSEMBLY