Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › from 2013.11
RM30B0U _56 Audio / Visual / Telematics _009403 AUDIO / VIDEO _0054849 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Data Signal Circuit between Radio Receiver and Extension Module  


DESCRIPTION

The stereo component tuner assembly sends a data signal or image data signal from a device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

E280906
6.125,0.427 6.74,0.625 0.615,0.198 10 false US4- 5.74,0.427 6.208,0.677 0.469,0.25 10 false W7 5.802,0.198 6.271,0.448 0.469,0.25 10 false 2 6.135,0.865 6.75,1.063 0.615,0.198 10 false US4+ 5.74,0.865 6.208,1.115 0.469,0.25 10 false W7 5.802,0.656 6.271,0.906 0.469,0.25 10 false 3 5.74,1.313 6.208,1.563 0.469,0.25 10 false W7 6.135,1.292 6.75,1.49 0.615,0.198 10 false UGD4 5.802,1.094 6.271,1.344 0.469,0.25 10 false 4 6.135,1.74 6.75,1.938 0.615,0.198 10 false USV4 5.74,1.75 6.208,2 0.469,0.25 10 false W7 5.802,1.531 6.271,1.781 0.469,0.25 10 false 1 6.135,2.188 6.75,2.385 0.615,0.198 10 false USG4 5.74,2.188 6.208,2.438 0.469,0.25 10 false W7 5.823,1.979 6.292,2.229 0.469,0.25 10 false 5 3.313,2.333 3.927,2.531 0.615,0.198 10 false Shielded 0.719,0.417 1.333,0.615 0.615,0.198 10 false US4- 0.708,0.854 1.323,1.052 0.615,0.198 10 false US4+ 0.667,1.313 1.281,1.51 0.615,0.198 10 false UGD4 0.688,1.75 1.302,1.948 0.615,0.198 10 false USV4 0.677,2.177 1.292,2.375 0.615,0.198 10 false USG4 1.208,0.427 1.677,0.677 0.469,0.25 10 false W9 1.271,0.208 1.74,0.458 0.469,0.25 10 false 2 1.219,0.865 1.688,1.115 0.469,0.25 10 false W9 1.281,0.656 1.75,0.906 0.469,0.25 10 false 3 1.219,1.313 1.688,1.563 0.469,0.25 10 false W9 1.281,1.094 1.75,1.344 0.469,0.25 10 false 4 1.219,1.75 1.688,2 0.469,0.25 10 false W9 1.281,1.531 1.75,1.781 0.469,0.25 10 false 1 1.208,2.188 1.677,2.438 0.469,0.25 10 false W9 1.292,1.979 1.76,2.229 0.469,0.25 10 false 5 6.135,2.885 6.75,3.083 0.615,0.198 10 false +B2 5.729,2.896 6.198,3.146 0.469,0.25 10 false W4 5.813,2.667 6.281,2.917 0.469,0.25 10 false 4 6.135,3.302 6.75,3.5 0.615,0.198 10 false ACC2 6.135,3.76 6.75,3.958 0.615,0.198 10 false GND2 5.729,3.333 6.198,3.583 0.469,0.25 10 false W4 5.802,3.125 6.271,3.375 0.469,0.25 10 false 3 5.74,3.771 6.208,4.021 0.469,0.25 10 false W4 5.823,3.552 6.292,3.802 0.469,0.25 10 false 8 0.781,2.885 1.396,3.083 0.615,0.198 10 false +B2 0.677,3.333 1.292,3.531 0.615,0.198 10 false ACC2 0.667,3.771 1.281,3.969 0.615,0.198 10 false GND2 1.208,2.896 1.677,3.146 0.469,0.25 10 false W5 1.281,2.677 1.75,2.927 0.469,0.25 10 false 4 1.208,3.333 1.677,3.583 0.469,0.25 10 false W5 1.281,3.125 1.75,3.375 0.469,0.25 10 false 3 1.208,3.771 1.677,4.021 0.469,0.25 10 false W5 1.271,3.563 1.74,3.813 0.469,0.25 10 false 8 0.135,4.896 1.302,5.479 1.167,0.583 10 false Stereo Component Tuner Assembly 5.896,4.917 7.094,5.333 1.198,0.417 10 false Radio and Display Receiver Assembly 2.885,5.135 4.333,5.302 1.448,0.167 10 false No. 1 Navigation Wire 0.917,6.385 2.75,6.583 1.833,0.198 10 false : LVDS Communication Line 6.146,4.375 6.76,4.573 0.615,0.198 10 false LV1 0.813,4.406 1.427,4.604 0.615,0.198 10 false LV1

CAUTION / NOTICE / HINT

NOTICE:
·

After replacing the stereo component tuner assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.

·

Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT TUNER ASSEMBLY)
a.

Disconnect the W4 and W7 radio and display receiver assembly connectors.


b.

Disconnect the W5 and W9 stereo component tuner assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
W7-1 (USV4) - W9-1 (USV4) Always Below 1 Ω
W7-2 (US4-) - W9-2 (US4-) Always Below 1 Ω
W7-3 (US4+) - W9-3 (US4+) Always Below 1 Ω
W7-4 (UGD4) - W9-4 (UGD4) Always Below 1 Ω
W7-5 (USG4) - W9-5 (USG4) Always Below 1 Ω
W4-4 (+B2) - W5-4 (+B2) Always Below 1 Ω
W4-3 (ACC2) - W5-3 (ACC2) Always Below 1 Ω
W4-8 (GND2) - W5-8 (GND2) Always Below 1 Ω
W7-1 (USV4) - Body ground Always 10 kΩ or higher
W7-2 (US4-) - Body ground Always 10 kΩ or higher
W7-3 (US4+) - Body ground Always 10 kΩ or higher
W7-4 (UGD4) - Body ground Always 10 kΩ or higher
W7-5 (USG4) - Body ground Always 10 kΩ or higher
W4-4 (+B2) - Body ground Always 10 kΩ or higher
W4-3 (ACC2) - Body ground Always 10 kΩ or higher
W4-8 (GND2) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.CHECK NO. 1 NAVIGATION WIRE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK NO. 1 NAVIGATION WIRE
a.

Replace the No. 1 navigation wire with a known good one.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>SATELLITE RADIO TUNER>REMOVAL


b.

Check that the malfunction disappears.

OK:

Malfunction disappears.



Result:
Proceed to
OK
NG



OK

END (NO. 1 NAVIGATION WIRE [LVDS COMMUNICATION LINE] IS DEFECTIVE)

NG