Home › Engine / Hybrid System › 1AD-FTV EMISSION CONTROL › EXHAUST FUEL ADDITION INJECTOR › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008371 1AD-FTV EMISSION CONTROL _0046706 EXHAUST FUEL ADDITION INJECTOR A

1AD-FTV EMISSION CONTROL  EXHAUST FUEL ADDITION INJECTOR  INSTALLATION  


PROCEDURE

Hide 23255B 1.INSTALL FUEL INJECTOR SEAL

a.

Install a new fuel injector seal to the exhaust fuel addition injector assembly.


Hide 23710B 2.INSTALL EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

NOTICE:

If there is foreign matter on the installation surface of the exhaust fuel addition injector assembly, be sure to clean the exhaust fuel addition injector assembly before installation.


a.

Install a new gasket, the exhaust fuel addition injector assembly, the nozzle holder clamp, and the washer with the bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)

HINT:
A201785C02
0.625,1.052 1.375,1.052 true 0.458,0.958 0.771,1.115 0.313,0.156 10 *1
*1 Nozzle Holder Clamp


Align the nozzle holder clamp with the cutouts of the exhaust fuel addition injector assembly as shown in the illustration.



Hide 23901E 3.INSTALL FUEL TUBE SUB-ASSEMBLY

Hide 23292D 4.INSTALL FUEL HOSE PROTECTOR

a.

Install the fuel hose protector with the bolt.

Torque:
21 N*m (209 kgf*cm, 15 ft.*lbf)


b.

Connect the exhaust fuel addition injector connector.


c.

Attach the 2 clamps and connect the turbocharger connector.


d.

Connect the suction control valve connector and fuel temperature sensor connector to the fuel supply pump assembly.


Hide 17801 6.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17705 7.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION