Home › Engine / Hybrid System › 2AD-FTV ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL
RM3090E _51 Engine / Hybrid System _008372 2AD-FTV ENGINE MECHANICAL _0046718 REAR CRANKSHAFT OIL SEAL A

2AD-FTV ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11401L 1.INSTALL REAR ENGINE OIL SEAL

a.

Apply MP grease to the lip of a new rear engine oil seal.


b.
A202329N01
0.42,2.769 0.746,2.952 0.326,0.183 10 SST 0.938,2.304 0.594,2.651 0.594,2.651 0.594,2.731 false

Using SST and a hammer, tap in the rear engine oil seal as shown in the illustration.

SST
09223-56010  

Standard depth:

0 to 0.9 mm (0 to 0.0354 in.)


NOTICE:
·

Keep the lip free from foreign matter.

·

Do not tap the rear engine oil seal at an angle.

·

Make sure that the rear engine oil seal is properly installed.




Hide 13450 2.INSTALL FLYWHEEL WITH DAMPER ASSEMBLY (for Manual Transaxle)

Hide 32101 3.INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)

Hide 31250 4.INSTALL CLUTCH DISC ASSEMBLY (for Manual Transaxle)

Hide 31210 5.INSTALL CLUTCH COVER ASSEMBLY (for Manual Transaxle)

Hide 31210 6.INSPECT AND ADJUST CLUTCH COVER ASSEMBLY (for Manual Transaxle)

Hide 30300 7.INSTALL MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)

Hide 30500 8.INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION