Home › Engine / Hybrid System › 2AD-FTV COOLING › WATER PUMP
RM3090E _51 Engine / Hybrid System _008373 2AD-FTV COOLING _0046724 WATER PUMP A

2AD-FTV COOLING  WATER PUMP  REMOVAL  


PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51443 2.REMOVE REAR ENGINE UNDER COVER RH

Hide 16470 5.REMOVE RADIATOR RESERVOIR ASSEMBLY

Hide 51217A 6.REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

Hide 16361A 7.REMOVE FAN AND GENERATOR V BELT

Hide 12305 9.REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH

a.
A235368

Remove the nut.


b.
A231499

Loosen the 4 bolts and 2 nuts from the front engine mounting insulator and rear engine mounting insulator.

HINT:

Loosen the bolts and nuts approximately 10 turns. Do not remove them.



c.
A295980

Place a wooden block between a jack and the engine.

NOTICE:

Make sure to set a jack as shown in the illustration. Do not place the jack on the oil pan sub-assembly.



d.

Jack up the engine slightly.


e.
A235369

Remove the 5 bolts, nut and engine mounting insulator sub-assembly RH.

HINT:

Jacking up the engine slightly makes the engine mounting insulator sub-assembly RH easier to remove.



Hide 12341 10.REMOVE ENGINE MOUNTING SPACER

a.
A295979

Remove the 2 bolts and engine mounting spacer.


Hide 16649B 11.REMOVE IDLER PULLEY COVER PLATE

Hide 16603 12.REMOVE NO. 1 IDLER PULLEY SUB-ASSEMBLY

Hide 16604 13.REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY

a.
A126838

Remove the pulley bolt, No. 2 idler pulley cover plate and No. 2 idler pulley sub-assembly.


Hide 16100 14.REMOVE ENGINE WATER PUMP ASSEMBLY

a.
A300908

Remove the 7 bolts, engine water pump assembly and gasket.