When replacing the injectors (including shuffling the injectors between the cylinders), common rail, intake manifold or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, intake manifold or cylinder head, it is necessary to replace the fuel inlet pipe with a new one.
1.INSTALL STUD BOLT
If a stud bolt is deformed or the threads are damaged, replace it.
| *a | 35 mm (1.38 in.) |
| *b | 20 mm (0.787 in.) |
| *c | 13 mm (0.512 in.) |
Using an E8 "TORX" wrench, install the 2 stud bolts.
17111
2.INSTALL INTAKE MANIFOLD
Install a new gasket to the cylinder head sub-assembly.
Install the gasket with the part labeled A facing the right side of the vehicle as shown in the illustration.
| *1 | Nut |
Install the intake manifold with the 7 bolts and 2 nuts.
| Item | Length |
|---|---|
| Bolt A | 90 mm (3.54 in.) |
| Bolt B | 25 mm (0.984 in.) |
25770A
3.CONNECT NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY
Connect the No. 2 vacuum transmitting hose assembly to the intake manifold, and slide the clamp to secure the hose.
17112
4.INSTALL NO. 2 INTAKE MANIFOLD
Install a new gasket and the No. 2 intake manifold with the bolt and 2 nuts.
12631A
5.INSTALL ENGINE COVER BRACKET
Install the engine cover bracket with the bolt.
17696
6.INSTALL GAS FILTER BRACKET
Install the gas filter bracket with the 2 bolts.
23265
7.INSTALL NO. 1 GAS FILTER
| *1 | Protrusion |
| *2 | Groove |
Install the No. 1 gas filter to the gas filter bracket.
Make sure the protrusion of the No. 1 gas filter is aligned with the groove of the gas filter bracket.
Connect the vacuum hose.
89421C
8.INSTALL DIESEL TURBO PRESSURE SENSOR
11452
9.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE
Install a new O-ring to the engine oil level dipstick guide.
Install the engine oil level dipstick guide with the 2 bolts.
Connect the connector and attach the wire harness clamp to the engine oil level dipstick guide.
Install the engine oil level dipstick.
17853B
10.INSTALL INTAKE MANIFOLD INSULATOR
Install the intake manifold insulator to the intake manifold.
23810A
11.INSTALL COMMON RAIL ASSEMBLY
23701
12.INSTALL INJECTION PIPE SUB-ASSEMBLY
23804C
13.INSTALL FUEL INLET PIPE SUB-ASSEMBLY
25800
14.INSTALL ELECTRIC EGR CONTROL VALVE ASSEMBLY
25602
15.INSTALL NO. 2 EGR PIPE SUB-ASSEMBLY
16296
16.CONNECT NO. 8 WATER BY-PASS HOSE
16295
17.INSTALL NO. 7 WATER BY-PASS HOSE
Install the No. 7 water by-pass hose to the electric EGR control valve assembly, and slide the clamp to secure the hose.
25625
18.INSTALL EGR VALVE BRACKET
19.CONNECT ENGINE WIRE
26100
20.INSTALL DIESEL THROTTLE BODY ASSEMBLY
21.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
22.BLEED AIR FROM FUEL SYSTEM
23.INSPECT FOR FUEL LEAK