The throttle actuator is operated by the ECM and opens and closes the throttle valve using gears. The opening angle of the throttle valve is detected by the throttle position sensor, which is mounted on the throttle body.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P2141 | Diesel Throttle Motor Circuit Low | The throttle actuator current is below 0.5 A for 2.0 seconds during EGR valve operation.
(1 trip detection logic) |
·
Open or short in throttle actuator circuit ·
Diesel throttle valve assembly ·
ECM |
Comes on | DTC stored |
| P2142 | Diesel Throttle Motor Circuit High | An throttle actuator current of 8 A or higher due to a mechanical malfunction, or a Hall IC temperature of 150 to 160°C (302 to 320°F) or higher is detected.
(1 trip detection logic) |
·
Open or short in throttle actuator circuit ·
Diesel throttle valve assembly ·
ECM |
Comes on | DTC stored |
| DTC No. | Data List |
|---|---|
| P2141 | Throttle Motor DUTY |
| P2142 |
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P2141 | Idle the engine for 5 seconds or more |
| P2142 |
After replacing the ECM, the new ECM needs registration (Click here Engine / Hybrid System>2AD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>REGISTRATION) and initialization (Click here Engine / Hybrid System>2AD-FTV ENGINE CONTROL>ECD SYSTEM(for DPF)>INITIALIZATION).
Inspect the diesel throttle body assembly.
Click hereEngine / Hybrid System>2AD-FTV ENGINE CONTROL>DIESEL THROTTLE BODY>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the diesel throttle body assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B3-2 (M+) - B76-42 (M+) | Always | Below 1 Ω |
| B3-1 (M-) - B76-43 (M-) | Always | Below 1 Ω |
| B3-2 (M+) or B76-42 (M+) - Body ground | Always | 10 kΩ or higher |
| B3-1 (M-) or B76-43 (M-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the ECM.
Click hereEngine / Hybrid System>2AD-FTV ENGINE CONTROL>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Repair or replace the harness or connector.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Clear the DTCs.
Start the engine.
Idle the engine for 5 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Confirm that the DTC is not output again.
| Proceed to |
|---|
| NEXT |
NEXT
Replace the diesel throttle body assembly.
Click hereEngine / Hybrid System>2AD-FTV ENGINE CONTROL>DIESEL THROTTLE BODY>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT