Home › Engine / Hybrid System › 3ZR-FAE FUEL › FUEL INJECTOR
RM3090E _51 Engine / Hybrid System _008388 3ZR-FAE FUEL _0046819 FUEL INJECTOR A

3ZR-FAE FUEL  FUEL INJECTOR  REMOVAL  


PROCEDURE

Hide 1. DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 11212 4.REMOVE NO. 2 CYLINDER HEAD COVER

Hide 17705 5.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 6.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 74404A 7.REMOVE BATTERY CLAMP SUB-ASSEMBLY

Hide 28800 8.REMOVE BATTERY

Hide 74431 9.REMOVE BATTERY TRAY

Hide 12.REMOVE WIRE HARNESS CLAMP BRACKET

a.
A205213

Remove the 2 nuts and wire harness clamp bracket.


Hide 23901 13.DISCONNECT FUEL TUBE SUB-ASSEMBLY

a.
A298977

Remove the No. 2 fuel pipe clamp and disconnect the fuel tube sub-assembly.

Click hereEngine / Hybrid System>3ZR-FAE FUEL>FUEL SYSTEM>PRECAUTION


Hide 23807 14.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

a.
A152570

Remove the bolt and wire harness bracket.


b.
A153007

Remove the 2 bolts.


c.
A205216

Remove the bolt and fuel delivery pipe sub-assembly.

NOTICE:

Be careful not to drop the fuel injectors when removing the fuel delivery pipe sub-assembly.



d.
A153008

Remove the 2 No. 1 delivery pipe spacers.


Hide 23250 15.REMOVE FUEL INJECTOR ASSEMBLY

a.
A153009

Pull the 4 fuel injector assemblies out of the fuel delivery pipe sub-assembly.


b.

Remove the O-ring from the fuel injector assembly.


c.
A171499

For reinstallation, attach a tag or label to the injector shaft.

NOTICE:

Prevent entry of foreign objects by covering the fuel injector assembly with plastic bags.



d.

Remove the 4 injector vibration insulators from the cylinder head.