Home › Engine / Hybrid System › 2AR-FE FUEL › FUEL PRESSURE PULSATION DAMPER
RM3090E _51 Engine / Hybrid System _008397 2AR-FE FUEL _0046883 FUEL PRESSURE PULSATION DAMPER A

2AR-FE FUEL  FUEL PRESSURE PULSATION DAMPER  INSTALLATION  


PROCEDURE

Hide 23270 1.INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY

a.
A196015C02
2.415,1.514 2.578,1.679 0.163,0.165 10 *1 2.604,1.604 2.787,1.604 2.787,1.604 3.007,1.06 false
*1 New O-Ring


Apply a light coat of gasoline or spindle oil to a new O-ring, and then install the O-ring to the fuel pressure pulsation damper assembly.


b.

Install the fuel pressure pulsation damper assembly with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

Make sure that the O-ring is not cracked or jammed when installing the fuel pressure pulsation damper assembly.



Hide 23901 2.CONNECT FUEL TUBE SUB-ASSEMBLY

Hide 23881B 3.INSTALL FUEL HOSE BRACKET

Hide 17705 4.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

Hide 12601B 5.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION