Home › Engine / Hybrid System › 2AD-FHV ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL
RM3090E _51 Engine / Hybrid System _008404 2AD-FHV ENGINE MECHANICAL _0046942 REAR CRANKSHAFT OIL SEAL A

2AD-FHV ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11401L 1.INSTALL REAR ENGINE OIL SEAL

a.

Apply MP grease to the lip of a new rear engine oil seal.


b.
A202329N02
0.854,2.219 0.594,2.646 0.594,2.646 0.594,2.729 true 0.479,2.771 0.802,2.958 0.323,0.188 10 SST

Using SST and a hammer, tap in the rear engine oil seal as shown in the illustration.

SST
09223-56010  

Standard depth:

0 to 0.9 mm (0 to 0.0354 in.)


NOTICE:
·

Keep the lip free from foreign matter.

·

Do not tap the rear engine oil seal at an angle.

·

Make sure that the rear engine oil seal is properly installed.




Hide 32101 2.INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION