11103
1.REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY
13716
2.REMOVE VALVE STEM CAP
11101
3.REMOVE CYLINDER HEAD SUB-ASSEMBLY
Using a 10 mm bi-hexagon wrench, uniformly loosen and remove the 10 cylinder head bolts and 10 plate washers in several steps in the sequence shown in the illustration.
Be careful not to drop washers into the cylinder head sub-assembly.
Head warpage or cracking could result from removing the bolts in the wrong order.
Using a screwdriver with its tip wrapped with tape, pry between the cylinder head sub-assembly and cylinder block, and remove the cylinder head sub-assembly.
Be careful not to damage the contact surfaces of the cylinder head sub-assembly and cylinder block.
11115
4.REMOVE CYLINDER HEAD GASKET
5.INSPECT CYLINDER HEAD FOR FLATNESS
6.INSPECT CYLINDER HEAD BOLT