Home › Engine / Hybrid System › 3ZR-FE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL › 2012.12–2015.04
RM3090E _51 Engine / Hybrid System _008405 3ZR-FE ENGINE MECHANICAL _0046946 FRONT CRANKSHAFT OIL SEAL A

3ZR-FE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11302A 1.INSTALL TIMING CHAIN COVER OIL SEAL

a.
A157500E01
0.733,0.299 1.021,0.483 0.288,0.184 10 SST 1.571,1.837 1.331,0.394 1.331,0.394 1.124,0.394 false

Apply MP grease to the lip of a new oil seal.

NOTICE:
·

Do not allow foreign matter to contact the lip of the oil seal.

·

Do not allow MP grease to contact the dust seal.




b.

Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.

SST
09223-22010  

NOTICE:
·

Wipe off any extra grease from the crankshaft.

·

Do not tap in the oil seal at an angle.




Hide 13471 2.INSTALL CRANKSHAFT PULLEY

a.
A236399C03
2.184,3.148 2.365,3.298 0.181,0.15 10 *a 2.357,0.522 2.671,0.719 0.314,0.198 10 SST 1.379,1.944 1.874,0.603 1.874,0.603 2.32,0.603 false 1.663,1.845 1.874,0.603 false
*a Hold
V100135

Turn


Align the key groove of the crankshaft pulley with the pulley set key.


b.

Temporarily install the crankshaft pulley with the pulley bolt.


c.

Using SST, hold the crankshaft pulley in place and tighten the pulley bolt.

for 86 mm (3.39 in.) Bolt Pitch Type:

SST
09213-58014  (91551-80840)
09330-00021  

for 64 mm (2.52 in.) Bolt Pitch Type:

SST
09213-54015  09330-00021  

Torque:
190 N*m (1937 kgf*cm, 140 ft.*lbf)

HINT:

For the 64 mm (2.52 in.) bolt pitch type, the part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).



Hide 51217A 6.INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

Hide 51443 9.INSTALL REAR ENGINE UNDER COVER RH

Hide 51441 10.INSTALL NO. 1 ENGINE UNDER COVER

Hide 11212 11.INSTALL NO. 2 CYLINDER HEAD COVER