1. DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
11212
4.REMOVE NO. 2 CYLINDER HEAD COVER
17705
5.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
6.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
74404A
7.REMOVE BATTERY CLAMP SUB-ASSEMBLY
28800
8.REMOVE BATTERY
74431
9.REMOVE BATTERY TRAY
82121
10.DISCONNECT ENGINE WIRE
Detach the 9 clamps and disconnect the 18 connectors.
Remove the 3 bolts and 3 nuts, and then disconnect the engine wire.
17361M
11.REMOVE AIR TUBE
| *1 | Fuel Vapor Feed Hose |
| *2 | Union to Connector Tube Hose |
| *3 | No. 1 Vacuum Transmitting Hose |
| *4 | No. 1 Fuel Vapor Feed Hose |
Slide the clamp and disconnect the fuel vapor feed hose from the purge VSV.
Slide the clamp and disconnect the union to connector tube hose from the air tube.
Slide the clamp and disconnect the No. 1 vacuum transmitting hose from the air tube.
Disconnect the No. 1 fuel vapor feed hose from the air tube.
Remove the 2 bolts and air tube.
25719
12.REMOVE VACUUM SURGE TANK
Disconnect the 2 air hoses from the purge VSV and intake manifold and detach the clamp.
Remove the 2 bolts and vacuum surge tank.
23901
13.DISCONNECT FUEL TUBE SUB-ASSEMBLY
Remove the No. 2 fuel pipe clamp and disconnect the fuel tube sub-assembly.
Click hereEngine / Hybrid System>3ZR-FE FUEL>FUEL SYSTEM>PRECAUTION
23807
14.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY
Remove the bolt and wire harness bracket.
Remove the 2 bolts.
Remove the bolt and fuel delivery pipe sub-assembly.
Be careful not to drop the fuel injectors when removing the fuel delivery pipe sub-assembly.
Remove the 2 No. 1 delivery pipe spacers.
23250
15.REMOVE FUEL INJECTOR ASSEMBLY
Pull the 4 fuel injector assemblies out of the fuel delivery pipe sub-assembly.
Remove the O-ring from the fuel injector assembly.
For reinstallation, attach a tag or label to the injector shaft.
Prevent entry of foreign objects by covering the fuel injector assembly with plastic bags.
Remove the 4 injector vibration insulators from the cylinder head.