1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL
51441
4.REMOVE NO. 1 ENGINE UNDER COVER
11212
5.REMOVE NO. 2 CYLINDER HEAD COVER
17705
6.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
74404A
7.REMOVE BATTERY CLAMP SUB-ASSEMBLY
Remove the bolt and loosen the nut.
Detach the hook of the battery clamp sub-assembly from the front battery bracket, and then remove the battery clamp sub-assembly.
28800
8.REMOVE BATTERY
74431
9.REMOVE BATTERY TRAY
16057
10.DISCONNECT RADIATOR HOSE SUB-ASSEMBLY
Remove the 2 bolts and disconnect the radiator hose sub-assembly from the front battery bracket.
74417
11.REMOVE FRONT BATTERY BRACKET
Detach the 3 wire harness clamps.
Remove the 4 bolts and front battery bracket.
74414B
12.REMOVE BATTERY BRACKET REINFORCEMENT
Remove the 2 bolts and battery bracket reinforcement.
33820B
13.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY (for CVT)
Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.
33823
14.REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET (for CVT)
28100
15.REMOVE STARTER ASSEMBLY
Disconnect the terminal cap.
Remove the nut and disconnect the starter wire.
Disconnect the starter connector.
Remove the 2 bolts and starter assembly.
11363A
16.REMOVE FLYWHEEL HOUSING SIDE COVER
Remove the flywheel housing side cover from the cylinder block.