Home › Engine / Hybrid System › 3ZR-FE STARTING › STARTER(for 1.0 kW Type)
RM3090E _51 Engine / Hybrid System _008411 3ZR-FE STARTING _0046982 STARTER(for 1.0 kW Type) A

3ZR-FE STARTING  STARTER(for 1.0 kW Type)  INSTALLATION  


PROCEDURE

Hide 11363A 1.INSTALL FLYWHEEL HOUSING SIDE COVER

a.

Install the flywheel housing side cover to the cylinder block.


Hide 28100 2.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly with the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


b.

Connect the starter connector.


c.

Connect the starter wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


d.

Connect the terminal cap.


Hide 33823 3.INSTALL NO. 1 TRANSMISSION CONTROL CABLE BRACKET (for CVT)

Hide 33820B 4.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY (for CVT)

a.

Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.


Hide 74414B 5.INSTALL BATTERY BRACKET REINFORCEMENT

a.

Install the battery bracket reinforcement with the 2 bolts.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


Hide 74417 6.INSTALL FRONT BATTERY BRACKET

a.

Install the front battery bracket with the 4 bolts.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


b.

Attach the 3 wire harness clamps.


Hide 16057 7.CONNECT RADIATOR HOSE SUB-ASSEMBLY

a.

Connect the radiator hose sub-assembly to the front battery bracket with the 2 bolts.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


Hide 74431 8.INSTALL BATTERY TRAY

Hide 28800 9.INSTALL BATTERY

Hide 74404A 10.INSTALL BATTERY CLAMP SUB-ASSEMBLY

a.

Attach the hook of the battery clamp sub-assembly to the front battery bracket.


b.

Partially tighten the nut and temporarily install the bolt.


c.

Adjust the battery clamp sub-assembly position.


d.

Tighten the nut and bolt.

Torque:
for bolt : 17 N*m (173 kgf*cm, 13 ft.*lbf)
for nut : 4.9 N*m (50 kgf*cm, 43 in.*lbf)


Hide 17705 11.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

Hide 12.CONNECT CABLE TO POSITIVE BATTERY TERMINAL

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 11212 14.INSTALL NO. 2 CYLINDER HEAD COVER

Hide 51441 15.INSTALL NO. 1 ENGINE UNDER COVER