When replacing the injector assemblies (including shuffling the injector assemblies between the cylinders), common rail assembly, intake manifold or cylinder head sub-assembly, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump assembly, common rail assembly, intake manifold or cylinder head sub-assembly, it is necessary to replace the fuel inlet pipe sub-assembly with a new one.
23810A
1.INSTALL COMMON RAIL ASSEMBLY
Install the common rail sub-assembly with the 2 bolts.
Connect the No. 4 fuel hose to the common rail assembly, and slide the clamp to secure it.
2.INSTALL INJECTION PIPE SUB-ASSEMBLY
23804C
3.INSTALL FUEL INLET PIPE SUB-ASSEMBLY
82121
4.CONNECT ENGINE WIRE
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
6.BLEED AIR FROM FUEL SYSTEM
7.INSPECT FOR FUEL LEAK
12611
8.INSTALL NO. 1 ENGINE COVER