Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0047056 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM C

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  B2450  Initialization has not been Performed  


DESCRIPTION

The headlight leveling ECU stores this DTC if initialization has not been performed after replacing the ECU.

DTC No. Detection Item DTC Detection Condition Trouble Area
B2450 Initialization has not been Performed Initialization of the headlight leveling ECU has not been performed.
·

Vehicle condition when initializing

·

Headlight leveling ECU assembly



CAUTION / NOTICE / HINT

HINT:

After replacing the headlight leveling ECU, initialization of the ECU is necessary.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION


PROCEDURE

1.PERFORM HEADLIGHT LEVELING ECU INITIALIZATION
a.

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR

Body Electrical > HL AutoLeveling > Trouble Codes
50001 165
Result:
Proceed to
DTC B2450 output does not occur
DTC B2450 output occurs


HINT:

If the headlight leveling ECU sets B2450 even though the ECU has been initialized, there may be a malfunction in the headlight leveling ECU.




DTC B2450 output does not occur

END

DTC B2450 output occurs

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY