The headlight leveling ECU stores this DTC if the sensor value received from the rear height control sensor is out of range when performing initialization of the headlight leveling ECU; for example, the vehicle is not level or is being jacked up.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2452 | Height Control Sensor Data Out of Range When Initializing | Value from rear height control sensor is out of the normal range when initializing. | ·
Vehicle condition when initializing ·
Headlight leveling ECU assembly |
After replacing the headlight leveling ECU, initialization of the ECU is necessary.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION
Perform initialization of the headlight leveling ECU.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION
Before initializing, make sure that the vehicle condition is proper for initialization.
Be sure to perform the initialization as instructed.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC B2452 output does not occur |
| DTC B2452 output occurs |
If the headlight leveling ECU sets B2452 even though the ECU has been initialized as instructed, there may be a malfunction in the headlight leveling ECU.
DTC B2452 output does not occur
DTC B2452 output occurs