Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM
RM3090E _59 Vehicle Exterior _008430 LIGHTING (EXT) _0047056 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM J

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  LVL Terminal Circuit  


DESCRIPTION

When terminals LVL and CG of the DLC3 are connected, the headlight leveling ECU initializes the height control sensor signal.

WIRING DIAGRAM

E227421E04
0.875,0.729 1.146,0.896 0.271,0.167 10 LVL 0.917,1.354 1.156,1.521 0.24,0.167 10 CG 1.25,0.583 1.375,0.771 0.125,0.188 10 8 1.24,1.229 1.365,1.427 0.125,0.198 10 4 0.49,2.729 0.854,2.896 0.365,0.167 10 G14 0.5,2.885 0.917,3.052 0.417,0.167 10 DLC3 5.615,2.719 6.042,2.906 0.427,0.188 10 A67 5.615,2.896 7.115,3.26 1.5,0.365 10 Headlight Leveling ECU Assembly 6,0.74 6.417,0.917 0.417,0.177 10 INIT 5.802,0.563 5.917,0.729 0.115,0.167 10 5

CAUTION / NOTICE / HINT

HINT:

After replacing the headlight leveling ECU, initialization of the ECU is necessary.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - HEADLIGHT LEVELING ECU ASSEMBLY)
a.

Disconnect the A67 headlight leveling ECU connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A67-5 (INIT) - G14-8 (LVL) Always Below 1 Ω
A67-5 (INIT) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)
a.
C166029C57
0.135,1.01 0.563,1.313 0.427,0.302 1.563,1.104 1.438,1.917 false 1.302,1.958 1.667,2.135 0.365,0.177 10 CG 0.125,0.073 0.344,0.25 0.219,0.177 10 *a 0.177,1.073 0.521,1.25 0.344,0.177 10 G14
*a Front view of DLC3


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G14-4 (CG) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR