Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for HDD) › 2012.12–2014.10
RM3090E _56 Audio / Visual / Telematics _008776 NAVIGATION / MULTI INFO DISPLAY _0048745 NAVIGATION SYSTEM(for HDD) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for HDD)  Steering Pad Switch Circuit  


DESCRIPTION

This circuit sends an operation signal from the steering pad switch assembly to the navigation ECU sub-assembly.

If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly.

If there is a short in the circuit, the same condition as when a switch is continuously depressed occurs.

Therefore, the navigation ECU sub-assembly cannot be operated using the steering pad switch assembly, and also the navigation ECU sub-assembly itself cannot function.

WIRING DIAGRAM

E269542E05
1.063,1.917 1.417,2.115 0.354,0.198 10 Right 1.646,1.917 2,2.115 0.354,0.198 10 Back 2.25,1.917 2.604,2.115 0.354,0.198 10 Enter 0.479,1.917 0.833,2.115 0.354,0.198 10 Left 0.271,0.833 0.854,1.021 0.583,0.188 10 Volume- 1.708,3.083 2.708,3.25 1,0.167 10 MODE/HOLD 4.271,0.594 4.51,0.771 0.24,0.177 10 z1 6.167,0.563 6.531,0.76 0.365,0.198 10 SW1 5.323,0.583 5.583,0.792 0.26,0.208 10 G8 5.375,0.385 5.583,0.594 0.208,0.208 10 6 4.729,2.5 5.083,2.698 0.354,0.198 10 AU3 1,3.833 2.917,4.063 1.917,0.229 10 Steering Pad Switch LH Side 0.542,4.854 0.958,5.052 0.417,0.198 10 Voice 2.01,4.865 2.583,5.063 0.573,0.198 10 On Hook 0.865,0.833 1.458,1.021 0.594,0.188 10 Volume+ 1.615,0.844 2.083,1.042 0.469,0.198 10 Down 2.375,0.865 2.656,1.104 0.281,0.24 10 Up 4.25,0.396 4.438,0.573 0.188,0.177 10 11 4.292,1.385 4.51,1.563 0.219,0.177 10 8 4.292,2.438 4.458,2.604 0.167,0.167 10 9 4.25,3.396 4.458,3.563 0.208,0.167 10 10 4.271,1.604 4.51,1.781 0.24,0.177 10 z1 4.281,2.646 4.521,2.823 0.24,0.177 10 z1 4.25,3.594 4.49,3.771 0.24,0.177 10 z1 5.323,1.594 5.583,1.802 0.26,0.208 10 G8 5.323,2.625 5.583,2.833 0.26,0.208 10 G8 5.313,3.594 5.573,3.802 0.26,0.208 10 G8 5.375,1.396 5.542,1.604 0.167,0.208 10 3 5.365,2.417 5.531,2.625 0.167,0.208 10 4 5.375,3.385 5.542,3.594 0.167,0.208 10 5 5.938,3.49 6.167,3.677 0.229,0.188 10 22 5.927,2.5 6.146,2.698 0.219,0.198 10 24 5.938,1.458 6.135,1.656 0.198,0.198 10 23 5.938,0.479 6.146,0.667 0.208,0.188 10 21 6.167,1.583 6.594,1.781 0.427,0.198 10 SWG 6.156,2.625 6.573,2.792 0.417,0.167 10 SW3 6.156,3.594 6.531,3.781 0.375,0.188 10 SW2 6,4.063 6.354,4.26 0.354,0.198 10 G139 6.021,4.24 7.083,4.594 1.063,0.354 10 Navigation ECU Sub-assembly 4.521,4.177 5.406,4.521 0.885,0.344 10 Spiral Cable Sub-assembly 1.219,4.865 1.792,5.063 0.573,0.198 10 Off Hook 1,6.156 2.99,6.365 1.99,0.208 10 Steering Pad Switch Assembly 0.958,5.635 2.875,5.865 1.917,0.229 10 Steering Pad Switch RH Side 4.75,0.469 5.104,0.667 0.354,0.198 10 AU1 4.729,1.469 5.083,1.667 0.354,0.198 10 EAU 4.729,3.469 5.083,3.667 0.354,0.198 10 AU2

CAUTION / NOTICE / HINT

NOTICE:

The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/o Occupant Classification System)>PRECAUTION


PROCEDURE

1.INSPECT STEERING PAD SWITCH ASSEMBLY
a.

Remove the steering pad switch assembly.

Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>REMOVAL


b.

Inspect the steering pad switch assembly.

Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY


Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY)

NG

3.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY)
a.

Disconnect the G139 navigation ECU sub-assembly connector.


b.

Disconnect the G8 spiral cable sub-assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G139-21 (SW1) - G8-6 (AU1) Always Below 1 Ω
G139-22 (SW2) - G8-5 (AU2) Always Below 1 Ω
G139-23 (SWG) - G8-3 (EAU) Always Below 1 Ω
G139-24 (SW3) - G8-4 (AU3) Always Below 1 Ω
G139-21 (SW1) - Body ground Always 10 kΩ or higher
G139-22 (SW2) - Body ground Always 10 kΩ or higher
G139-23 (SWG) - Body ground Always 10 kΩ or higher
G139-24 (SW3) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR