Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
47313A
2.DISCONNECT FRONT FLEXIBLE HOSE
Remove the bolt and disconnect the flexible hose.
3.DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
Remove the 2 bolts and disconnect the front disc brake caliper assembly from the steering knuckle.
Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.
43512
4.REMOVE FRONT DISC
43502D
5.REMOVE FRONT AXLE HUB BOLT LH
| *1 | Nut |
| *a | Hold |
| *b | Turn |
Temporarily install 2 nuts and 2 washers to the front axle hub bolt as shown in the illustration.
Using SST and a brass bar or an equivalent tool to hold the front axle, remove the front axle hub bolt.
43502D
6.INSTALL FRONT AXLE HUB BOLT LH
| *1 | Washer |
| *2 | Nut |
| *a | Hold |
| *b | Turn |
Install a washer and nut to a new front axle hub bolt as shown in the illustration.
Using a brass bar or an equivalent tool to hold the front axle, install the hub bolt by tightening the nut.
Remove the nut and plate washer.
43512
7.INSTALL FRONT DISC
8.CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
Connect the front disc brake caliper assembly to the steering knuckle with the 2 bolts.
47313A
9.CONNECT FRONT FLEXIBLE HOSE
Connect the front flexible hose to the steering knuckle with the bolt.
10.INSTALL FRONT WHEEL