42305
1.INSTALL REAR AXLE CARRIER SUB-ASSEMBLY LH
Temporarily install the rear axle carrier to the rear upper control arm with the bolt and nut.
48740F
2.TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY LH
Install the rear lower coil spring insulator to the rear No. 2 suspension arm.
| *a | 10 mm or less |
Install the rear upper coil spring insulator to the rear coil spring.
Install the rear upper coil insulator so that the distance between the stopper and upper end of the rear coil spring is 10 mm (0.394 in.) or less.
| *a | Identification Mark |
Install the rear coil spring to the rear No. 2 suspension arm.
Make sure that the identification mark is positioned towards the outer sides of the vehicle.
Using a jack and wooden block, raise the vehicle gradually to install the rear No. 2 suspension arm to the rear axle carrier. Then temporarily install the bolt.
When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
Do not jack up the rear No. 2 suspension arm assembly too high as the vehicle may fall.
Make sure to perform this operation with the vehicle kept as low as possible.
48710B
3.INSTALL REAR TRAILING ARM ASSEMBLY
Install the rear trailing arm to the axle carrier with the 2 bolts.
48720A
4.INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH
Install the rear No. 1 suspension arm to the rear axle carrier with a new nut.
48517A
5.INSTALL REAR SHOCK ABSORBER BRACKET LH
Install the rear shock absorber bracket to the rear axle carrier with the 2 bolts.
89408C
6.INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Automatic Headlight Beam Level Control System)
7.STABILIZE SUSPENSION
48790
8.TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH
Tighten the bolt.
Since a stopper nut is used, tighten the bolt.
48740F
9.TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH
Tighten the bolts of the suspension arm.
10.CONNECT PARKING BRAKE ASSEMBLY
Connect the parking brake assembly to the rear axle carrier with the nut.
46430
11.CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Connect the No. 3 parking brake cable to the rear trailing arm with the bolt.
48840A
12.INSTALL REAR STABILIZER LINK ASSEMBLY LH
42450B
13.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH (for 2WD)
42440
14.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH (for 4WD/AWD)
42312B
15.INSTALL REAR AXLE SHAFT NUT LH (for 4WD/AWD)
16.INSPECT REAR AXLE HUB BEARING LOOSENESS
17.INSPECT REAR AXLE HUB RUNOUT
42431
18.INSTALL REAR DISC
19.CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH
89516D
20.CONNECT SKID CONTROL SENSOR WIRE LH (for 2WD)
21.CONNECT REAR SPEED SENSOR LH (for 4WD/AWD)
42312B
22.STAKE REAR AXLE SHAFT NUT LH (for 4WD/AWD)
23.INSTALL REAR WHEEL
24.INSPECT AND ADJUST PARKING BRAKE
25.INSPECT AND ADJUST REAR WHEEL ALIGNMENT
26.CHECK FOR SPEED SENSOR SIGNAL