Home › Steering › STEERING COLUMN › STEERING WHEEL › 2012.12–2015.10
RM3090E _55 Steering _008773 STEERING COLUMN _0049427 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.


·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 84610F 1.INSTALL TRANSMISSION SHIFT SWITCH ASSEMBLY (w/ Shift Paddle Switch)

Hide 45184 2.INSTALL STEERING WHEEL BOSS LOWER COVER

a.

w/o Shift Paddle Switch

i.

Attach the 2 guide pins and 4 claws to install the lower cover.



b.

w/ Shift Paddle Switch

i.

Attach the 2 guide pins and 2 claws to install the lower cover.


ii.

Install the 2 screws.



Hide 84250A 3.INSTALL STEERING PAD SWITCH ASSEMBLY

a.

Attach the 6 claws and 2 pins to install the steering pad switch assembly.


b.

Install the 2 screws.


c.

Connect the connector to the spiral cable.

HINT:

If the vehicle is equipped with a shift paddle switch, connect the connector and the connector clamp.



Hide 84633 4.INSTALL CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)

a.

Install the cruise control switch wire to the cruise control main switch.


Hide 84632 5.INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

Hide 6.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 45100 8.INSTALL STEERING WHEEL ASSEMBLY

a.

Align the matchmarks on the steering wheel assembly and steering main shaft.


b.

Install the steering wheel assembly set nut.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


c.

Connect the connectors to the spiral cable sub-assembly.


Hide 10.INSPECT STEERING WHEEL CENTER POINT

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).