84250A
1.INSTALL STEERING PAD SWITCH ASSEMBLY
Attach the 6 claws and 2 pins to install the pad switch assembly.
Install the 2 screws.
Connect the connector to the spiral cable.
If the vehicle is equipped with a cruise control switch and shift paddle switch, connect their connectors and connector clamps.
45130
2.INSTALL STEERING PAD
for Single Type: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD(for Single Type)>INSTALLATION
for Dual Type: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD(for Dual Type)>INSTALLATION
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
4.CHECK SRS WARNING LIGHT
w/ Occupant Classification System: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/ Occupant Classification System)>DIAGNOSIS SYSTEM
w/o Occupant Classification System: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/o Occupant Classification System)>DIAGNOSIS SYSTEM