Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL
RM3090E _54 Brake _008768 BRAKE SYSTEM (OTHER) _0049558 BRAKE PEDAL A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 47110 1.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

a.

Install the brake pedal support assembly with the 4 nuts.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)


b.

Install the brake pedal support reinforcement set bolt.

Torque:
23.6 N*m (241 kgf*cm, 17 ft.*lbf)


Hide 47264A 2.INSTALL PUSH ROD PIN

C278584C01
0.063,0.115 0.26,0.323 0.198,0.208 10 *A 3.531,0.094 3.76,0.292 0.229,0.198 10 *B
*A for LHD *B for RHD
V100135

Lithium soap base glycol grease - -


a.

Apply a light coat of lithium soap base glycol grease to the push rod pin.


b.

Set the push rod clevis in place, insert the push rod pin from outside the vehicle and then a new clip.

NOTICE:

After installation, check that the pedal operates smoothly.



Hide 47101A 3.INSTALL BRAKE PEDAL RETURN SPRING

a.

Install the brake pedal return spring to the brake pedal support assembly.


Hide 84340 4.INSTALL STOP LIGHT SWITCH ASSEMBLY

Hide 5.CONNECT CONNECTORS

a.

Connect the brake pedal load sensing switch connector.


b.

Connect the stop light switch connector.


Hide 73900 7.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

Hide 55432B 8.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Driver Side Knee Airbag)

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 10.CHECK AND ADJUST BRAKE PEDAL