Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
84306
1.INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR
Install the spiral cable with steering angle sensor.
for Singl Type:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE(for Single Type)>INSTALLATION
for Dual Type:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE(for Dual Type)>INSTALLATION
Do not replace the spiral cable with the battery connected and the ignition switch ON.
Do not rotate the spiral cable with the battery connected and the ignition switch ON.
w/ Vehicle Stability Control System:
Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
Do not remove the steering angle sensor from the spiral cable.
45286
2.INSTALL STEERING COLUMN COVER
45100
3.INSTALL STEERING WHEEL ASSEMBLY
45130
4.INSTALL STEERING PAD ASSEMBLY
5.INSPECT STEERING WHEEL CENTER POINT
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
45130
7.INSPECT STEERING PAD ASSEMBLY
8.CHECK SRS WARNING LIGHT
w/ Occupant Classification System:
w/o Occupant Classification System: