Home › Power Source / Network › 1AD-FTV BATTERY / CHARGING › GENERATOR › 2012.12–2015.10
RM3090E _57 Power Source / Network _008779 1AD-FTV BATTERY / CHARGING _0049700 GENERATOR A

1AD-FTV BATTERY / CHARGING  GENERATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 16361A 4.REMOVE FAN AND GENERATOR V BELT

Hide 43410 5.REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

Hide 6.REMOVE WIRE HARNESS CLAMP BRACKET

a.
A297139

Disconnect the sensor connector and detach the wire harness clamp.


b.

Remove the bolt and wire harness clamp bracket.


Hide 27020 7.REMOVE GENERATOR ASSEMBLY

a.
A297140

Remove the bolt and disconnect the wire harness bracket from the generator assembly.


b.

Remove the terminal cap.


c.

Remove the nut and disconnect the wire harness from terminal B.


d.

Disconnect the connector from the generator assembly.


e.
A297141

Remove the 3 bolts and generator assembly.