Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
87510N
1.INSTALL FRONT SEATBACK HEATER ASSEMBLY LH
Set the front seatback heater assembly LH on the separate type front seatback cover.
Using a tacker, install the front seatback heater assembly LH to the separate type front seatback cover with 14 new tack pins as shown in the illustration.
Do not substitute other metal parts for tack pins.
71074S
2.INSTALL SEPARATE TYPE FRONT SEATBACK COVER
71931
3.INSTALL FRONT SEAT HEADREST SUPPORT
4.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY
71862
5.INSTALL FRONT INNER SEAT CUSHION SHIELD LH
71861
6.INSTALL FRONT INNER SEAT CUSHION SHIELD RH (for Front Passenger Side)
71812D
7.INSTALL FRONT SEAT CUSHION SHIELD LH
72495
8.INSTALL VERTICAL ADJUSTING HANDLE LH
72526A
9.INSTALL RECLINING ADJUSTER RELEASE HANDLE LH
10.INSTALL FRONT SEAT ASSEMBLY LH
11.INSPECT SEAT HEATER SYSTEM