Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO RECEIVER › 2012.12–2013.11
RM3090E _56 Audio / Visual / Telematics _008775 AUDIO / VIDEO _0049775 RADIO RECEIVER A

AUDIO / VIDEO  RADIO RECEIVER  INSTALLATION  


PROCEDURE

Hide 86211 1.INSTALL NO. 1 RADIO BRACKET

a.

Install the No. 1 radio bracket with the 3 screws.


Hide 86212 2.INSTALL NO. 2 RADIO BRACKET

a.

Install the No. 2 radio bracket with the 3 screws.


Hide 86120 3.INSTALL RADIO RECEIVER ASSEMBLY

a.

Connect each connector.


b.

Attach the 4 clips to install the radio receiver assembly with bracket.


c.

Install the 4 bolts.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 83950M 4.INSTALL TELLTALE LIGHT ASSEMBLY

Hide 55670 5.INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55680A 6.INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55412C 7.INSTALL NO. 1 CENTER INSTRUMENT CLUSTER FINISH PANEL

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION