Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices befor eproceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
74646A
4.REMOVE DOOR ASSIST GRIP COVER LH
69284D
5.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
67842E
7.REMOVE REAR DOOR SERVICE HOLE COVER LH
67408E
8.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68124B
9.REMOVE REAR DOOR QUARTER WINDOW GLASS LH
68104
10.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
68152C
11.REMOVE REAR DOOR GLASS RUN LH
69060A
12.REMOVE REAR DOOR WITH MOTOR LOCK ASSEMBLY LH
| *A | w/o Double Locking System |
| *B | w/ Double Locking System |
Disconnect the connector.
Using a T30 "TORX" socket wrench, remove the 3 screws.
| *a | Downward |
Move the rear door with motor lock assembly LH downward and pull the release plate out of the rear door outside handle frame.
Remove the rear door with motor lock assembly LH and cables as a unit.
Remove the door lock wiring harness seal from the rear door with motor lock assembly LH.
69740D
13.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
69780B
14.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH