Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) › 2012.12–2015.10
RM3090E _58 Vehicle Interior _008789 HEATING / AIR CONDITIONING _0049189 AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)  B1451  Compressor Solenoid Circuit  


DESCRIPTION

In this circuit, the compressor assembly with pulley (compressor solenoid) receives a refrigerant compression demand signal from the air conditioning amplifier assembly.

Based on this signal, the compressor assembly with pulley (compressor solenoid) changes the amount of compressor output.


DTC No. Detection Item DTC Detection Condition Trouble Area Memory
B1451 Compressor Solenoid Circuit Open or short in compressor solenoid circuit
·

Compressor assembly with pulley (compressor solenoid)

·

Harness or connector

·

Air conditioning amplifier assembly


-

WIRING DIAGRAM

E229254E30
4.969,0.792 5.156,0.969 0.188,0.177 10 11 3.833,0.802 3.927,0.979 0.094,0.177 10 2 2.448,0.802 2.542,0.979 0.094,0.177 10 1 5.208,0.906 5.667,1.083 0.458,0.177 10 SOL+ 3.385,0.99 3.76,1.167 0.375,0.177 10 SOL+ 2.604,1 2.948,1.177 0.344,0.177 10 SOL- 4.854,3.531 5.198,3.708 0.344,0.177 10 G80 4.865,3.698 6.51,4.031 1.646,0.333 10 Air Conditioning Amplifier Assembly 2.25,1.5 4.365,1.823 2.115,0.323 10 Compressor Assembly with Pulley (Compressor Solenoid) 2.25,1.333 2.667,1.51 0.417,0.177 10 B30

PROCEDURE

1.INSPECT COMPRESSOR ASSEMBLY WITH PULLEY (COMPRESSOR SOLENOID)
a.
E180798N02
1.49,1.125 1.188,0.573 1.188,0.573 0.958,0.573 false 2.042,1.135 2.281,0.594 2.281,0.594 2.469,0.594 false 0.531,0.49 0.938,0.656 0.406,0.167 10 false SOL+ 2.531,0.521 2.938,0.688 0.406,0.167 10 false SOL-

Remove the compressor assembly with pulley (compressor solenoid).

for 1AD-FTV, 2AD-FHV, 2AD-CCo, 2AD-DPF:

Click hereVehicle Interior>HEATING / AIR CONDITIONING>COMPRESSOR(for 1AD-FTV, 2AD-FHV, 2AD-FTV)>REMOVAL

for 2AR-FE:

Click hereVehicle Interior>HEATING / AIR CONDITIONING>COMPRESSOR(for 2AR-FE)>REMOVAL

for 3ZR-FE, 3ZR-FAE:

Click hereVehicle Interior>HEATING / AIR CONDITIONING>COMPRESSOR(for 3ZR-FE, 3ZR-FAE)>REMOVAL


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (SOL-) - 2 (SOL+) 20°C (68°F) 10.1 to 11.1 Ω



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (COMPRESSOR ASSEMBLY WITH PULLEY [COMPRESSOR SOLENOID] - BODY GROUND)

NG

REPLACE COMPRESSOR ASSEMBLY WITH PULLEY (COMPRESSOR SOLENOID)

2.CHECK HARNESS AND CONNECTOR (COMPRESSOR ASSEMBLY WITH PULLEY [COMPRESSOR SOLENOID] - BODY GROUND)
a.
E185639C01
0.333,1.063 0.833,1.333 0.5,0.271 1.448,1.417 1.208,1.719 false 0.115,0.104 0.365,0.281 0.25,0.177 10 *a 0.438,1.115 0.74,1.26 0.302,0.146 10 B30 0.906,1.719 1.302,1.865 0.396,0.146 10 SOL-
*a Front view of wire harness connector
(to Compressor Assembly with Pulley)


Disconnect the compressor assembly with pulley (compressor solenoid) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
B30-1 (SOL-) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - COMPRESSOR ASSEMBLY WITH PULLEY [COMPRESSOR SOLENOID])

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - COMPRESSOR ASSEMBLY WITH PULLEY [COMPRESSOR SOLENOID])
a.

Disconnect the G80 air conditioning amplifier assembly connector.


b.

Disconnect the B30 compressor with pulley assembly (compressor solenoid) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G80-11 (SOL+) - B30-2 (SOL+) Always Below 1 Ω
G80-11 (SOL+) - Body ground Always 10 kΩ or higher



Result:
Result Proceed to
OK (When troubleshooting according to Problem Symptoms Table) A
OK (When troubleshooting according to the DTC) B
NG C



A

B

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

C

REPAIR OR REPLACE HARNESS OR CONNECTOR