1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
16361A
2.REMOVE V-RIBBED BELT
for 1AD-FTV: Click hereEngine / Hybrid System>1AD-FTV ENGINE MECHANICAL>DRIVE BELT>REMOVAL
for 2AD-FHV: Click hereEngine / Hybrid System>2AD-FHV ENGINE MECHANICAL>DRIVE BELT>REMOVAL
for 2AD-FTV: Click hereEngine / Hybrid System>2AD-FTV ENGINE MECHANICAL>DRIVE BELT>REMOVAL
51441
3.REMOVE NO. 1 ENGINE UNDER COVER
51444C
4.REMOVE REAR ENGINE UNDER COVER LH
51443
5.REMOVE REAR ENGINE UNDER COVER RH
51425B
6.REMOVE ENGINE FRONT MOUNTING BRACKET REINFORCEMENT LOWER (for 1AD-FTV)
51218A
7.REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT LH
51217A
8.REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH
57104E
9.REMOVE FRONT CROSSMEMBER SUB-ASSEMBLY
17343D
10.REMOVE NO. 3 AIR HOSE
17362B
11.REMOVE NO. 2 AIR TUBE
88703
12.DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY
Remove the bolt and disconnect the discharge hose sub-assembly from the compressor assembly with pulley.
Remove the O-ring from the discharge hose sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
88704
13.DISCONNECT SUCTION HOSE SUB-ASSEMBLY
Remove the bolt and disconnect the suction hose sub-assembly from the compressor assembly with pulley.
Remove the O-ring from the suction hose sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
88310
14.REMOVE COMPRESSOR ASSEMBLY WITH PULLEY
Disconnect the connector and detach the harness clamp.
Remove the 2 bolts and 2 nuts.
Using an E8 ''TORX'' socket wrench, remove the 2 stud bolts and compressor assembly with pulley.