1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
17141
3.REMOVE EXHAUST MANIFOLD WITH TURBOCHARGER
13511
4.REMOVE CAMSHAFT
23710B
5.REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY
23255B
6.REMOVE FUEL INJECTOR SEAL
19850
7.REMOVE GLOW PLUG ASSEMBLY
11101
8.REMOVE CYLINDER HEAD SUB-ASSEMBLY
Uniformly loosen the 10 bolts in several steps in the sequence shown in the illustration. Remove the 10 cylinder head bolts and 10 plate washers.
Head warpage or cracking could result from removing bolts in the incorrect order.
11115
9.REMOVE CYLINDER HEAD GASKET